Dirty flat iron detonates your hair and can damage the appliance: there is a right way to clean
If you use it, you know that after a lot of straightening, the flat iron accumulates dirt and some remnants of your hair products. It may even seem that this accumulation of black scabs on the edge of the board is harmless, but in reality, it is not. It can, in addition to damaging the device, detonate your hair. This is explained by hairdresser Gil Prando, iCabelos ambassador, who teaches the right way to clean. To get additional details, view here: how to clean flat iron
How to clean flat iron
According to the professional, the cleaning of the flat iron should always be done before use.
To do this, just pass a slightly damp flannel. It is important to make sure that it is unplugged.
Only after cleaning should it be connected and used normally. "When the flat iron is clean, it has a greater slip, avoiding pulling the wires", he explains. Therefore, if you do not worry about cleaning it, it may end up impairing the sliding of the board, which will make the heat stay in contact with the wires longer, weaken and cause it to break and even fall, in some cases .
Right way to degrease the flat iron for hair:
Don't you live without your flat iron, are you addicted to serums and creams to comb and never take a break from this life to degrease your thermal appliance? Your flat iron must be full of residues of creams and thermal protectors, the ideal would be to clean it every 15 days, at least. Learn the right way to go.
Tip to clean the flat iron
Remove the plug, separate a clean flannel to wet it in water and, with the help of a little neutral soap, remove the grease from the metal or ceramic surface of the flat iron. Then use a dry flannel to remove any leftover product, water or soap.
How to clean flat iron
Before you start, you will need a cloth, a cotton swab, cotton and some surface cleaning product. With everything in hand, here's how to clean the flat iron.
Start by heating your flat iron slightly.
Two or three minutes is enough. Then, unplug the equipment and carefully check that the flat iron is warm and not too hot.
Clean the ceramic plates with a cloth.
Put some of the product of your choice, such as Creamy Multi-Purpose Cif on the cloth and pass through the ceramic plates. Clean the folds and corners of the flat iron.
Put some of the same product on a cotton swab and clean all parts of the flat iron, including the most difficult to reach, such as buttons and textures.
Remove excess product with a cotton pad.
Finally, remove excess product with a damp cotton (with a minimum of warm water).
Now that you know how to clean your hair straightener, be sure to dry the flat iron completely before using it or plugging it in again.